Publicidad
Idiomas disponibles
Idiomas disponibles
•
Hold down the [ID] button (2) while powering up the HYBRID TRANSCEIVER.
The status LED (3) will briefly turn WHITE, then change to GREEN, BLUE or YELLOW (reflecting the last selected mode).
Select Yellow by briefly pressing the [ID] button (2).
•
•
Once yellow is selected, hold the [ID] button (2) for 3 seconds to confirm the easylink mode.
•
The status LED will transition to white and then blinks colors and shows universal color.
•
Now you can select your universe color by just setting it on a universe color
DMX
Universe
1
•
2
•
3
•
4
•
•
5
•
6
•
7
To disconnect all receivers from a DMX universe/transmitter:
Press the [ID] button (2) of the transmitter for approximately 3 seconds until the status LED (3) turns RED. The status LED on the receiver(s)
•
will momentarily turn WHITE (disconnected) and then switch to RED (no signal present).
•
After a brief interval, the status LED (3) on the transmitter will revert to WHITE.
•
To reconnect the receiver(s), simply press briefly on the [ID] button (2) on the transmitter. The status LED (3) on the receiver(s) will turn GREEN
again.
Press the [ID] button (2) of the receiver for about 3 seconds until the status LED (3) turns WHITE.
This action disconnects the receiver from the transmitter (DMX universe).
Colour
DMX Channels
Red
000 ~ 512
•
•
Green
000 ~ 512
•
•
Yellow
000 ~ 512
•
•
Blue
000 ~ 512
•
•
•
Magenta
•
000 ~ 512
•
Cyan
•
000 ~ 512
•
White
•
000 ~ 512
Publicidad
