Melchioni Family CUBIK Manual De Instrucciones página 12

1) Connect the appliance to the power socket, the ICE MAKING light flashes and the machine will start the defrost
function. Press the POWER button, the ICE MAKING light will become fixed and ice block production will start
automatically. At the end of the ice making defrost will be performed, then the ice shoveling function and so on.
2). ADD WATER: no water alarm
When the ADD WATER light turns red, it means there is a shortage of water in the water tank. You need to add water
and press the POWER button to restart the machine.
3) ICE FULL: Full ice alarm
When the ice reaches the maximum capacity of the ice bin, the ICE FULL light flashes and the machine stops. At this
point the ice container must be emptied. When the amount of ice is less than the sensor position, the machine will
restart automatically.
4) ICE MAKING: Ice production
When this light is always on, it means that the machine is preparing ice.
INSTRUCTIONS FOR USE
STEP 1
Open the lid, take out the basket and add water to the tank.
Note: There is a maximum MAX scale in the tank. The water must not exceed the MAX position. If the water exceeds
the maximum MAX scale, it is necessary to open the lower drain plug, release the excess water and cover with a
transparent cover.
STEP 2
Connect the power and press the POWER button to start the machine.
1. The ice produced in the first three cycles is small and patchy.
2. When the ice basket is full, take out the ice immediately, do not let the ice come out of the
ATTENTION!
basket.
3. Due to rapid freezing, the ice cubes may be opaque. This is air trapped in the water and will
not affect the quality or taste of the ice
CLEANING AND MAINTENANCE
Caution: The plug must be removed before cleaning to avoid electric shock.
1. Frequently clean the inside of the appliance, the ice collection tray, the water box, the ice scoop and the evaporator.
When cleaning, unplug the appliance from the mains and remove the ice cubes. Use a diluted solution of water and
vinegar to clean the inside and outside of the appliance. Do not use chemicals or diluted agents such as acids,
gasoline or cleaning oil. Rinse thoroughly before use. Do not pour water on the cable, plug and ventilation, immerse
the appliance in water or other liquids.
2. Keep the air intakes away from obstacles. Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
3. When using the machine after a period of inactivity, it may not have enough water. In this case, the "ADD WATER"
indicator will light up. Just press the POWER button to restart the device.
4. To ensure the transparency of the ice, change the water in the tank at least once a day. If you do not use the
appliance for a long period of time, it is recommended to drain the water and clean it.
5. If the compressor freezes due to lack of water, too much water or power failure, it will delay 3 minutes to start after
restart.
6. Always use fresh water before you start making ice, both for first use and after a long period of inactivity.
PROBLEMS AND SOLUTIONS
No. Problem Problem analysis
11
Solution