Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION!
Hot surface. Risk of burns.
Before use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
The recommended ambient temperature
range for using tools and batteries is between
-5°C and 50°C.
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket. The
control LED
lights up red.
♦
The green control LED
charging process is complete and the battery
pack
is ready.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
PDSSA 20-Li B2
to the rapid
(see Fig. A).
indicates that the
flashes, this means
has overheated and
both
♦
Insert the battery pack
appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦
Push the rotation direction switch
the middle position (lock). Allow the battery
pack
to click into the handle.
Removing the battery pack
♦
Press the release button
battery pack.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦
To start the appliance, press the ON/OFF
switch
light
lights up when the ON/OFF switch
is depressed lightly or fully. This allows for illumi-
nation of the work area in low lighting.
Switching off
♦
Release the ON/OFF switch
is
appliance.
back into the
and remove the
as follows:
and keep it pressed in. The LED work
GB │ IE
into
to
to switch off the
│
7
■
Publicidad
