GE AEQ05 Serie Manual Del Propietario Y Instrucciones De Instalación página 6

About the controls on the air conditioner.
Do Not Operate in Freezing Outdoor
Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Hake sure nothing is between the air conditioner
and the remote control that could block the
signal.
The remote control signal has o range of
up to 20 feet.
Make sure batteries ore fresh and installed
correctly as indicated on the remote control.
Remote contains o magnet allowing it to attach
to metal surfaces.
6
Cool Mode
Use the Cool mode ot Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase •
/Decrease • pods to set the desired temperature
between 64°F and 86°F in Z% increments.
An electronic thermostat is usedto rnointoin the room
temperature. The compressor will cycle on und off
to keep the room at the set level of comfort. Setthe
thermostat at o lower number and the indoor air will
become cooler. Setthe thermostat at o higher number
and the indoor air will become wormer.
NOTE:If the air conditioner is off and is then turned on
while set to o Cool setting or if turned from o fan setting
to o Cool setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling-Select the Cool mode and
High or F/ed fan with o middle set temperature.
For Maximum Cooling--Select the Cool mode
and High fan with o lower set temperature.
For Quieter and Nighttime Cooling-Select the
Cool mode and Low fan with o middle set
temperature.
Energy Saver Mode
Controls the fan.
ON--The fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally used when the
room is unoccupied. NOTE:Thefan may continue to
run for o short time after the compressor cycles off.
OFF--The fan runs oil the time, while the compressor
cycles on and off.
Fan Only Mode
Use the Fan Only Node at Low, Ned or High fan
speed to provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, o Set temperature cannot be entered. The
room temperature will appear
in the display.
NOTE:Auto Fan Speedcannot be used when in the
Fan Only Mode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.
NOTE:Auto Fan Speedcannot be used when in the
Fan Only Mode.
Power Outage Recovery Feature
In the case of o power outage or interruption, the
unit will automatically restart in the settings lost
used offer the power is restored. If the Delay 1-24hr
feature was set, it will resume countdown. You may
need to set o new time if desired.