Husqvarna EPOS RS1 Manual De Usuario página 12

2. Log on to your Husqvarna account in the
Automower ® Connect app.
®
3. Start Bluetooth on your mobile device.
My mowers in the Automower
4. Select
app and add your product.
5. Enter the factory PIN code.
6. Follow instructions for the EPOS
®
Automower Connect app. Do a paring operation
with the reference station and the charging station
and install the map objects.
Note:
It is only necessary to do a pairing operation of
®
the Automower Connect app and the product one time.
®
3.10.3 Automower Connect
®
Automower Connect is a free app for your mobile
device. Use the app for installation, settings and
operation of your product. You can also find more
information for example about alarm and statistics in the
®
Automower Connect app.
The app gives 2 modes of connectivity: Long-
range cellular connectivity and Short-range Bluetooth
connectivity.
• Dashboard that shows the current status of the
product and the battery state of charge.
Note:
All countries do not support cellular connection
®
to Automower Connect because of regional specified
cellular systems. The included Automower
lifetime service only applies if there is a third part sub-
supplier of available in the operational area.
3.10.4 Installation of the charging station
Read and understand the instructions about the
To examine where to put the
charging station. Refer to
charging station on page 7 .
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When you connect the power supply, only use a power
outlet that is connected to a residual-current device
(RCD).
12 - Installation
®
Connect
™
setup in the
®
®
Connect
Make sure that the plugs of
3.10.4.1 To install the charging station
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 7 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
installed.
3. Open the hatch on the front of the charging station.
4. Attach the top of the charging station.
5. Tilt the top of the charging station.
6. Put the grommet with the cables into position.
7. Connect the cable to the charging station.
Make sure that the plugs of
To examine where to put
2211 - 002 - 30.11.2023