To Change The Pre-Filter; Filter Change; To Change The Hepa Filter; Troubleshooting - HTC D 10 Manual Del Usuario

• All parts that are contaminated after service work
must be disposed in a correct procedure in plastic
bags. Refer to local regulations.
• Use correct personal equipment when you clean the
Personal protective equipment on
product. Refer to
page 20 .
• Clean the external surface with a moist cloth.
• Clean the filters and the dust extractor in applicable
area.
• Vacuum the pre-filter from the inside. Always use
dust extractors with Filtre HEPA and a soft brush to
not damage the filter.
• Do not use water on electrical components.
• Do not clean the dust extractor with high pressure
(air or water).
• Do not put tools on the surface of the filter, it can
cause damage to the filter.
• Do not make a hole in the Filtre HEPA, it can cause
a health risk.

Filter change

WARNING: Use personal safety equipment,
Personal protective equipment on
refer to
page 20 , during filter change. Dust can
come out during filter change.
WARNING: Always turn the motor switch in
the Off position and disconnect the cord
from the wall outlet during filter change.

To change the HEPA filter

CAUTION: Do not clean HEPA filters. Trying
to clean a HEPA filter will destroy it. When
installing the replacement filter, make sure to
not touch the inside of the filter. Any kind of
force/damage on the inside of filter media
will destroy the new filter.

Troubleshooting schedule

Issue
Motor does not start
Motor stops immediately after
starting
24

Troubleshooting

Cause
No power
Cable defective
Switch defective
Soft start defective
Wrong fuse
Shortcut in cable/machine
Note: Recommended intervals for filter change: Pre-filter
every 6 months and HEPA filters every 12 months.
1. Loosen the screws on the filter cover cap.
2. Carefully lift the filter into a clean plastic bag, this
bag must be properly disposed.
3. Insert a new filter in reverse order.

To change the pre-filter

CAUTION: When you remove the pre-filter in
order to clean it, use only low pressure water
from the inside through to the out. Hitting the
filter with force, high pressure water or use
of compressed air will destroy the filter. The
filter must be 100% dry before returning into
the housing.
1. Loosen the 3 toggle fastners and remove the top.
2. Take the bag from the new filter.
3. Lift out the filter and place it gently in a plastic bag.
This bag must be properly disposed.
4. Insert a new filter.
Solution
Plug in machine
Replace cable
Replace switch
Replace soft start
Connect to correct fuse
Order service
949 - 002 - 08.04.2019