DeLOCK 18159 Manual Del Usuario página 3

English
Operation
1. Plug-in 20 / 24 pin connector to the power tester.
2. Switch on your power supply.
3. Check the voltage in the display.
4.
Connect P4 connector to the 4 pin female connector of the
power tester.
5. Check the voltage in the display.
6. Plug-in the HDD cable.
7.
The LED's +12 V and +5 V should light up.
8.
Remove the HDD cable.
9. Plug-in a floppy cable.
10. The LED's +12 V and +5 V should light up.
11. Remove the Floppy cable.
12. Plug-in a SATA cable.
13. The LED's +12 V, +3.3 V and +5 V should light up.
14. Remove the SATA cable.
15. Plug-in 6 pin and 8 pin connector one after the other.
16. Check the voltage in the display.
17. If the LED's do not light up, then the power supply is damaged.
-3-