Publicidad
Idiomas disponibles
Idiomas disponibles
Unfolding the stroller
To unfold the stroller, lay it flat on the ground (Fig. 1),
release the frame lock (Fig. 2), and pull the handle up
firmly (Fig. 3) until you hear the folding mechanism
click into place (Fig. 4).
Mounting and dismounting
the rear wheels
To assemble the rear wheels of the stroller, first push
the half-shafts with the pointed side into the rear
brake rod (Fig. 5) until they are fully engaged (Fig. 6).
Press the button in the middle of the wheel and then
put the wheels on the half-shafts until you hear a click.
To remove the rear wheels, press the button in the cen-
ter of the wheel (Fig. 7) and remove it.
Mounting the front castor wheels
Place the front wheel set on the hub (Fig. 9) until a
clear click is felt. Make sure that the wheel is proper-
ly locked. Repeat the procedure for the second wheel.
The front wheels can be locked for straight travel. Turn
the locking ring on the top of the front wheel to lock
the wheel (Fig. 10).
Disassembly of the
front steering wheels
Press the button located in the center of the locking
function (on the top of the front wheel) (Fig. 11) and
pull the wheel out of the hub (Fig. 12). Repeat the pro-
cedure for the second wheel.
1
2
3
4
5
6
7
8
9
10
Adjusting the height of the handle
The stroller has a height-adjustable handlebar. Oper-
ate the round buttons on the handle located on both
inner sides and set the desired height (Fig. 13).
Kick-down brake
The stroller is equipped with a kick-down brake on the
11
12
rear axle. Operate the brake pedal to lock the wheels
(Fig. 14) and operate it again to release the brake.
Caution! The brake is not used to slow down the ride
and should only be applied when the stroller is at a
complete standstill.
Caution! The stroller is not suitable for running.
Caution! Before driving, make sure that the brake is
released.
Caution! Always block the brake when you park the
13
14
stroller on an inclined plane.
Assembly and disassembly
of the carrycot
The carrycot of the stroller is assembled by pressing it
onto the frame. The adapters on the sides of the carry-
cot must be clicked into the latching tabs of the stroller
(Fig. 15, 16). The locking mechanism is automatic. To
remove the carrycot, press the button on each of the
latching tabs and pull the carrycot upwards.
15
16
The carrycot can be folded flat. To fold the carrycot,
please remove the mattress and the inner fabric of the
carrycot. Release the two clip fasteners on the sides
next to the sun canopy (Fig. 17) and then the Velcro
fasteners that run around the carrycot (Fig. 18, 19).
Then pull both metal rods inside the carrycot towards
the center and the carrycot will fold up (Fig. 20).
To unfold the carrycot, push the metal rods back into
the recess provided for this purpose in the bottom of
the carrycot.
17
18
17
18
Important note! Before use, make sure that the carry-
cot is correctly assembled.
19
20
Publicidad
