Sofirn SC32 Manual página 4

flash twice to indicate the flashlight is in lock mode when you try other operations.
ON/OFF. When the light is turned on again, it will return to the previously memorized mode. Turbo and
Strobe are not in the memory mode.
When the flashlight is off, press and hold the switch to access the Moon. Single click to turn off, or hold
and press to access Low cycling through Low, Medium, and High.
SWITCH BETWEEN DIFFERENT GROUPS
While flashlight is on, fast four clicks to switch between group 1 and group 2. LED blinks twice to signal
that the group switch is completed.
 GROUP 2
When the flashlight is off, single click the switch to turn the light on.
CHANGE BRIGHTNESS LEVEL: Hold and press the switch to change brightness steplessly. Ramping
changes its direction when the button is being pressed again within 1.5 seconds. The LED flashes once
when it reaches the lower or upper end of the ramp.
Other operations are the same as GROUP 1.
Troubleshooting and Maintenance
 Disassembling the sealed head can damage flashlight and voids warranty.
 Sofirn, Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids
warranty.
 Remove battery if the flashlight will not be used for an extended period of time.
 To prevent accidental activation during storage or transportation, unscrew the head by half a turn or
remove battery.
 Every 6 months threads should be wiped with a clean cloth followed by a thin layer of silicone grease.
 To maintain a proper level of waterproofness, replace worn-out o-rings with an approved spare (2
pieces are shipped with initial order).
 Troubleshooting: Cleaning battery contacts regularly as dirty contacts may impair the performance of
the flashlight. If you experience problems (flicker, shine intermittently or failure turn on) the
following root causes and solutions should be tried:
Reason A: The battery needs replacement (Battery voltage is below 2.8V).
Solution: Replace battery with an approved type of fully charged battery.
Reason B: Threads, PCB board contact or other contacts are dirty.
Solutions: Please clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods do not work please refer to the warranty policy before contacting your authorized