1. IMPORTANT
SAFETY
INSTRUCTIONS
Read these instructions carefully
and retain them for future use� If this
product is passed to a third party,
these instructions must be included�
When using electrical appliances, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and/
or injury to persons including the following:
WARNING
Risk of fire or electric
shock!
» To reduce the risk of fire or electric
shock, do not expose this product to
rain or moisture�
» Before cleaning, switch the product off
and disconnect the adaptor mains plug
from the mains outlet�
CAUTION
Risk of explosion!
» Improper replacement of the batteries
poses a risk of explosion� Replace
batteries only with the same or
equivalent type of battery�
» Do not move the product from cold
to warm places and vice versa�
Condensation can cause damage to the
product and electrical parts�
» Do not use attachments or accessories
other than recommended by the
manufacturer or sold with this product�
Install in accordance with this user
manual�
» When installing the product, leave
sufficient space for ventilation (minimum
10 cm around the product)� Do not install
in bookcases, built-in cabinets or the like�
» Do not impede ventilation by covering the
ventilation openings with items, such as
newspapers, table-cloths, curtains, etc�
Do not insert any objects�
» Do not install near any heat sources,
such as radiators, heat registers, stoves
or other products (including amplifiers)
that produce heat�
» Do not shift or move the product when
connected to the mains�
» Do not touch, push or rub the surface
of the product with any sharp or hard
objects�
» The product shall not be exposed to
dripping or splashing liquids and no
objects filled with liquids, such as vases,
shall be placed on the product�
» Care should be taken so that no objects
or liquids enter the housing through the
openings�
» No naked flame sources, such as
lit candles, should be placed on the
product�
» Refer all servicing to an authorised
service agent� Do not attempt to repair
the product yourself� Servicing is required
when the product has been damaged
in any way, such as if the mains cord
or plug are damaged, liquid has been
spilled, objects have fallen into the
product, the housing is damaged, the
product has been exposed to rain or
moisture, does not operate normally or
has been dropped�
» Before connecting the product to a mains
outlet, make sure the voltage indicated
on the product corresponds to your local
mains�
» Only use the provided adaptor�
» The adaptor mains plug is used as
the disconnect device; the disconnect
device shall remain readily operable� To
completely disconnect the power input,
disconnect the adaptor mains plug�
» The product may not function properly or
not react to the operation of any control
due to electrostatic discharge� Switch off
and disconnect the product; reconnect
after a few seconds�
EN
3