Beem Air Joy Hot&Cool Manual De Instrucciones página 18

14 EN
Indicator light
Colour Function
blue The appliance is set to cold air.
red The appliance is set to warm air.
Safety equipment
A safety switch is located on the underside
of the pedestal. The appliance then switches
itself off automatically if it is tipped or falls
over.
1. For this reason, always place the appli-
ance on a firm and even surface so that the
safety switch is in contact with the surface.
2. Switch on the device.
To check the function of the safety switch,
proceed as follows:
1. Lift the pedestal of the appliance slightly
so that there is no contact to the surface. The
safety equipment switches off the appliance.
2. Put the appliance back onto a firm, flat
surface and switch it on manually.
NOTE
► If the safety equipment switched off
the appliance, it does not NOT switch on
again automatically. It must be switched on
manually.
In addition, the appliance is protected against
overheating. This switches off the appliance
to prevent overheating when an ambient
temperature of approx. 30° C is reached.
This temperature is reached quickly if the
appliance is located in a confined space.
Therefore, allow sufficient space so that air
can circulate.
If the appliance switches off after overhea-
ting, proceed as follows:
1. Switch off the main switch of the appli-
ance and pull the plug out of the mains so-
cket. Allow the appliance and surroundings to
cool down.
BEEM - Elements of Lifestyle
2. Switch on the appliance again manually
when the temperature of the appliance and
the surroundings has fallen.
NOTE
► If the overheat protection switches
off the appliance, the appliance does not
switch back on again automatically - even
after the surrounding temperature has
fallen. You must switch the appliance back
on manually.
► If you manually switch on the appliance
again and it switches back off after a few
seconds, neither the temperature of the
appliance nor its surroundings has fallen
sufficiently.
Operation and use
Switching the appliance on/off
To switch off the appliance, proceed as
follows:
1. Move the main ON/OFF switch on the
pedestal to the "I" position.
2. Press the button on the control
panel (5) once to switch the appliance to cold
air. The blue indicator lamp lights bars 1, 2 or
3 depending on the airflow set.
3. Press the button on the control pan-
el (5) twice to switch the appliance to warm
air. The three bars remain red ALWAYS.
To switch off the appliance, proceed as
follows:
1. If the appliance does not produce a cold
airflow, press the
blue indicator lamp extinguishes.
2. If the appliance produces a warm airflow,
press the button once. The red indica-
tor lamp extinguishes.
3. Move the main ON/OFF switch (3) on the
pedestal to the „0" position.
button twice. The