Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 2: ASSEMBLY OF THE INDIVIDUAL PARTS
4. Remove the adjustment unit and the
fi xing arms from the round guide rails.
Secure the adjustment unit with the
M5x40 hexagon socket screws (4) to
the long or short telescopic tube (D).
If the screw holes do not fi t over each
other, turn the adjusting screw (H- ho-
rizontal rotation) until all three holes
match the thread of the telescopic
tube. Tighten the M5 hexagon socket
screws carefully hand-tight.
5. Slide the two round guide rails into
the adjustment unit and then attach
the two projector mounting arms (see
fi g. 6).
STEP 3: MOUNTING THE BRACKET TO THE PROJECTOR
6. Mount the bracket with the projector mounting arms (E) to the existing
mounting points of your projector. Make sure that the lens is on the same side
as the logo plate of the bracket. Use the Allen screws (1), (2) or (3) according
to the mounting points of your projector. If the screws are too long, use the
spacers (8). If the screws are too short, get suitable screws (min. 5 mm screw-
in depth in the projector). If your projector has only three mounting points,
align the bracket appropriately and leave the free mounting arm unused.
Setting
horizontal
rotation
Hexagon socket screw M5x40 mm (4)
Fig. 3: Assembly of the individual
Fig. 4: Completed assembly of the
parts (optional)
individual parts
6
Publicidad
