Publicidad
Idiomas disponibles
Idiomas disponibles
INTERNAL CARE
Filtering system
The filtering system in the base of the
wash cabinet retains coarse debris from
the washing cycle, including foreign
objects such as tooth picks or shards. The
collected
coarse debris may cause the filters to clog.
Check the condition of the filters regularly,
carefully remove foreign objects and clean
the parts of the filtering system if necessary
with water. Follow the steps below to clean
the filter. (see image 23 on page 11).
75.
Hold the coarse filter and rotate it
2 anticlockwise to unlock the filter.
Lift the filter upwards and out of the
dishwasher.
76.
The fine filter can be pulled off
the bottom of the filter assembly. The
coarse filter can be detached from the
main filter by gently squeezing the
tabs at the top and pulling it away.
• Main filter
• Coarse filter
• Fine filter
77.
Larger food remnants can be 4
cleaned by rinsing the filter under
running water. For a more thorough
clean, use a soft cleaning brush.
78.
Reassemble the filters in the
reverse order of the disassembly,
replace the filter insert, and rotate
clockwise to the close arrow.
Note: Pictures are only for reference,
different models of the filtering system and
spray arms may be different
Do not over tighten the filters.
Put the filters back in sequence
securely,
debris could get into the system
and cause a blockage.
Never
without
Improper replacement of the
filter
performance
appliance and damage dishes and utensils.
otherwise
coarse
use
the
dishwasher
filters
in
place.
may
reduce
level
of
Spray arms
It is necessary to clean the spray arms
regularly for hard water chemicals will
clog the spray arm jets and bearings.
To clean the spray arms, follow the
instructions below (see image 24 on page
11):
79.
To remove the upper spray arm,
hold the nut, rotate the arm clockwise
to remove it.
80.
To remove the lower spray arm,
pull out the spray arm upward.
81. Wash the arms in soapy and warm
water and use a soft brush to clean the
jets. Replace them after rinsing them
thoroughly.
CARING FOR THE DISHWASHER
Frost precaution
Please take frost protection measures on
the dishwasher in winter. Every time after
washing cycles, please operate as follows:
• Cut off the electrical power to the
dishwasher at the supply source.
• Turn
off
disconnect the water inlet pipe from
the water valve.
• Drain the water from the inlet pipe and
water valve. (Use a pan to gather the
water)
• Reconnect the water inlet pipe to the
water valve.
• Remove the filter at the bottom of the
tub and use a sponge to soak up water
in the sump.
After every wash
After every wash, turn off the water supply
to the appliance and leave the door slightly
open for a while so that moisture and odors
are not trapped inside.
Remove the plug
Before
cleaning
maintenance, always remove the plug
from the socket.
the
the
No solvents or abrasive cleaning
• To clean the exterior and rubber parts of
the
water
supply
or
performing
EN
and
53
Publicidad
