Publicidad
Idiomas disponibles
Idiomas disponibles
1. TEST AND ADJUSTMENT.
•
Turn ON the circuit breaker and light switch.
•
To test the light during daylight, cover the photocell with black
tape and ensure the light works properly.
•
Uncover the photocell and your unit will operate automatically:
ON at dusk, OFF at dawn.
2. ADJUSTING THE BRIGHTNESS LEVEL.
•
The brightness of the light can be adjusted between high
(6000LM) and low (3000LM).
•
To prolong the original appearance, clean with clear water and a soft, damp cloth only.
•
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature deterioration of the finish.
This is not a defect in the finish and will not be covered by the warranty.
•
Do not spray with a hose or power washer.
Problem
Light will not come ON.
Light turns OFF too late
when Dawn Daylight arrives.
Light stays ON continuously.
OPERATION:
CARE AND CLEANING:
TROUBLE SHOOTING GUIDE:
Possible cause
1.
The fuse is blown or the circuit breaker is
turned OFF.
2.
Daylight turn-off (photocell) is in effect.
3.
The circuit wiring is incorrect, if this is a new
installation.
1.
The light fixture may be installed in a
relatively dark location.
1.
The light fixture is wired through a dimmer
or timer.
2.
The light fixture is on the same circuit as a
motor, transformer, or fluorescent bulb.
3.
Something is blocking or covering the
photocell.
Photocell location
Solution
1.
Replace the fuse or turn the circuit breaker
ON.
2.
Recheck after dark.
3.
Verify the wiring is correct.
1.
Relocate the light fixture.
1.
Do not use a dimmer or timer to control the
light fixture. Replace the dimmer or timer
with a standard ON/OFF wall switch.
2.
Install the light fixture on a circuit without
motors, transformers, or fluorescent bulbs.
3.
Clean the photocell area.
Publicidad
