ENGLISH
PRODUCT FEATURES
The package contains a controller and the manual.
See Figure 01 on page 4.
Note: Image for guidance. Contents may vary from
model to model.
1.
Wall box adapter
2.
Indicator light
3.
Push buttons
4.
Controller housing
ASSEMBLY AND INSTALLATION
Before unpacking the product, please note the
location of each accessory in case it needs to be
repacked in the future.
If the product has been damaged, please contact the
shop where it was purchased.
• The manufacturer is not responsible for any
damage to the product caused by improper
installation.
• Before using the product for the first time,
remove all protective films and adhesive
strips.
• Place all parts of the product on a padded
surface, such as a carpet, or use the carton to
avoid blows or scratches.
Batteries
The controller is powered by 2 AAA batteries,
located in the back of the unit by removing the
cover.
Wall Mounting
Please note that the product can be used whether it
is mounted on the wall or not.
If you wish to install it on the wall, you will need
to have a suitable hole and frame in which to place
the product.
Note: The wall frame is not supplied with the
product.
Once you have completed the above (see picture 03
on page 5), install the wall box:
• Make the hole and install the wall box and
attach the adapter to the wall box with two
screws.
• Insert the batteries into the wall controller.
• Attach the wall controller, which is snapped
onto the adapter, to the wall box.
USING THE APPLIANCE
In order your controller work with your ceiling fan,
you must perform the pairing procedure:
• Close the power input to your ceiling fan
using the wall switch and wait about 5
seconds.
• Press and hold the Fan OFF button while
opening the power input with the wall
switch. Note that the control light should
illuminate while the button is being pressed.
• The link is complete.
Please note that the wall controller is compatible
with the following models:
• UVT1328-21
• UVT1329-21
• UVT1330-21
• UVT1318-21
• UVT1319-21
• UVT1320-21
• UVT1336-21
• UVT1315-21
Buttons
Refer to figure 02 on page 4 to familiarise yourself
with the buttons on the control panel:
5.
F button: press this button to run the fan
in SUMMER mode.
6.
ALL OFF button: press this key to switch
off the fan and the light.
7.
LIGHT ON/OFF button: press to turn the
light on or off. If you want to change
the light colour, press as many times as
necessary to set the desired colour.
8.
Buttons 1 to 6: Press buttons 1 to 6 to
adjust the fan speed. 1 is the lowest
speed and 6 is the highest speed. Press
one of these buttons to turn the fan on.
9.
R button: Press this button to operate the
fan in WINTER mode.
10.
8H button: Sets the fan to turn off
automatically
operation.
11.
FAN OFF key: Press this key to stop the
fan.
12.
4H button: Setting for the fan to turn
off automatically after four hours of
operation.
13.
2H button: Setting for the fan to turn
off automatically after two hour of
operation.
14.
Button
NATURAL mode
CLEANING AND MAINTENANCE
This product does not require much maintenance.
To clean it, please follow the instructions below:
after
eight
hours
: Press to set the air in
of