Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions
a
ae
ee
1. Warranty card
The serial number is written on the rear panel of this unit.
Copy the serial number and model number onto your warran-
ty card and keep it in a safe place.
Power
WARNING
BEFORE TURNING ON POWER FOR THE FIRST TIME, READ
THE FOLLOWING SECTION CAREFULLY.
e Some models are designed for use only with the power
supply voltage of the region where they are sold.
e@ U.K. and Australian models:
AC 240V, 50Hz
@ European models (except U.K.)
AC 220V, 50Hz
oe U.S.A. and Canadian models:
AC 120V, 60Hz
e@ Worldwide models:
AC 120 and 220V
switchable, 50/60Hz
e Voltage selector (rear pane!)
Worldwide models are equipped with a voltage selector to
conform with local power supplies. Be sure to set this
switch to match the power supply in your area before turn-
ing the power switch on. Voltage is changed by sliding
the groove in the switch with a screwdriver to the right or
left. Confirm that the switch has been moved all the way
to the right or left before turning the power switch on.
Models without a voltage selector can only be used in
areas where the power supply voltage is the same as that
of the unit.
—
220V ~~ 120V \
220V © 120V ~\
at AC 120V
at AC 220V
WORLDWIDE MODELS ONLY
®
®
©
—_
Deck location
e Do not use or leave in direct sunlight or in other places sub-
ject to high temperature and humidity. The unit should
also not be left in potentially hot places such as near heat-
ing appliances. Excessive heat and moisture can lead to in-
ternal damage and serious malfunctions (this also applies
to cassette tapes). The recommended ambient tempera-
ture range is 5°C to 35°C.
e Avoid damp and dusty places and locations prone to vibra-
tions.
e Be extremely careful with the recording/playback heads.
Clean and demagnetize them regularly, but under no cir-
cumstances should magnets or other metals be used
anywhere near the heads.
@ This unit is extremely sensitive to magnetic fields, so do
not use near large speakers or other devices which
generate magnetic fields.
@ Hum may even be induced by magnetic flux leakage from
the power transformer in certain amplifiers. Therefore, this
unit should also be kept clear of the amplifier.
e@ Do not remove the cabinet case. if any of the internal parts
are handled, there is a considerable danger of electric
shock,
Cassettes to avoid:
e Cassettes with poorly formed cases that rattle during
rewind and fast forward.
e Low cost cassettes with no guide roller or pressure pad
spring should never be used for stereo.
e C-120 cassettes — because the tape and the coating are
extremely thin, distortion levels are high. Also, even a
slight stretching of the tape will make it susceptible to
being caught up in the pinch roller and capstan.
e Endless tapes, if used for a long period of time, can over-
heat.
@ Dolby noise reduction and HX PRO headroom extension
manufactured under license from Dolby Laboratories
Licensing Corporation. HX PRO originated by Bang and
Olufsen. "Dolby," the double-D symbol and "HX PRO" are
trademarks of Dolby Laboratories Licensing Corporation.
e Recording of copyrighted material for other than personal
use is illegal without permission of the copyright holder.
System connections
All connections should be made with the power OFF. Hook up to
the amplifier:
Rt
REMOTE
CONTROL
Remote contro! cable
from an Onkyo amplifier,
receiver or CD player
bearing the R1 mark.
UNE
IN-LINE
OUT:
Integrated Amplifier
To tape playback
or auxiliary
input terminalis
To recording
terminals
For playback from deck =>
@
For recording on deck
Headphone jack
Dynamic type headphones with a rated impedance in the 8 to 200
ohm range are recommended.
Remote control jack
For remote control operation, connect this jack and any Onkyo
amplifier, receiver or CD player bearing the RI mark using the sup-
plied remote control cable. (Record/pause, stop, forward play,
reverse play, fast-forward and rewind operations can be ac-
complished via remote control.) See the instruction manual of
your amplifier, receiver or CD player for details.
Note:
Do not attempt to connect the RI remote control jack to any
equipment other than an Onkyo component bearing the RI
mark. Doing so could cause the unit to malfunction.
Publicidad
