Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking
1.
Remove unit from carton and discard all packag-
ing. NOTE: Save all parts bags.
Assemble
Handle
1.
Insert the handle inside the compressor saddle
and line up the two bolt holes on each side.
2.
Install the four screws, two on each side.
3.
Tighten securely.
Screw
Assemble
Wheels
.
it will be necessary
to brace
or support
one side of the
outfit when installing the wheels because the
compressor
will have a tendency
to tip.
Attach wheels with shoulder bolts and nuts as
shown.
2.
Tighten securely. NOTE: The outfit will sit level if
the wheels are properly installed.
I___
The wheels and handle
do not provide adequate
clearance, stability
or support
for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.
Assemble
Rubber Feet
1.
Attach rubber feet with the screws, washers and
nuts provided as shown in previous figure.
2.
Tighten securely.
'_
Flat Washer
i_-_
Rubber Foot
Screw
Shoulder
Bolt
D24305
8- ENG
Publicidad
