Publicidad
Idiomas disponibles
Idiomas disponibles
•
Use recommended
accessories (refer to page 17).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
•
Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figures 2, 3, 4 and 24.
ATTACH SUPPORT
TO JOINTER
•
Attach fence support to jointer with socket head bolts
and lock washers.
•
Insert locking plate assembly into support. Position
plate so that pins are against bottom edge of sup-
port.
•
Secure plate in position with fence sliding handle and
spacer.
Fence Sliding Handle_
_.
Spacer _
"!
Fence Support
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a
claim must be filed with carrier. Check for complete-
ness. Immediately report missing parts to dealer.
The jointer/planer is shipped complete in one carton.
Additional parts which need to be fastened to
jointer/planer should be located and accounted for
before assembling.
A
Jointer Bed Assembly
B
Fence
C
Fence Support
D
Fence Bracket Assembly
E
Locking Plate Assembly
F
Fence Sliding Handle with Spacer
G
Push Blocks (2)
H
Fence Tilting Handle with Spacer
I
Dust Chute
Hardware bag includes:
.
8-1.25 x 20mm Socket Head Bolts (6)
o 8mm LockWasher
(6)
.
4 and 6mm Hex Wrench
.
6-1.0 x 25mm Pan Head Screw
I
Figure 1 - Unpacking
g Plate
Assembly
Figure 2 - Attach Fence Support
INSTALL
FENCE AND FENCE BRACKET
TO
JOINTER
•
Attach fence to fence bracket assembly with four
socket head bolts and lock washers.
•
Slide fence and bracket over and onto dovetails of
support and locking plate.
•
Continue to slide fence forward so that the fence is
over the jointer tables. At this position the edge of
the blade guard will rest against the fence, and the
entire width of the cutterhead is covered. Secure
bracket in position with fence sliding handle.
•
Insert fence tilting handle with spacer through right
link and thread into left link.
Fence Tilting
Handle
_,
Fence Bracket
3ort
Figure 3 - Attach Fence Assembly
.
Make sure limit plate (Figure 4, page 4) is resting in
slot of block. Position fence against shaft and lock
fence in position with fence tilting handle.
3
Publicidad
