Publicidad
Idiomas disponibles
Idiomas disponibles
•
Remove four bolts (Key No. 24) that retain motor
mounting plate (Key No. 49).
Rem'_e
""
Figure 23 - Replacing Timing Belt
•
Remove drive belt (Key No. 53).
•
Replace with new drive belt. Make sure belt seats
fully in grooves of both pulleys and install motor
plate to base with the four bolts. Do not completely
tighten bolts.
•
Push motor assembly towards the right to apply ten-
sion to the drive belt. Tighten bolts securely.
•
Replace fan belt onto cutterhead pulley, making sure
belt seats properly in grooves of both pulleys.
•
Replace access cover using two screws
•
Replace bottom cover using four screws.
REPLACING
FAN BELT
• Turn the switch to OFF position and unplug the tool
from power source.
•
Lay the jointer/planer
on the side so that the switch
is facing upward.
•
Remove four screws and bottom cover (Key Nos. 37
and 54).
•
Remove two screws and access cover (Key Nos. 37
and 38).
•
Loosen chip exhaust housing (Key No. 21) by
removing two socket head bolts (Key No. 24).
•
Remove old fan belt and place new belt over fan
pulley.
• Attach chip exhaust housing to base with the two
belts.
•
Pull belt over cutterhead pulley making sure the belt
seats in grooves of both pulleys.
GENERAL
MAINTENANCE
Jointer/planer will operate best if it is kept in good oper-
ating condition. Keep unit adjusted as described in
"Operation."
•
Do not allow gum and pitch to accumulate on the
tables, fence, blades and blade guard.
• Apply a thin coat of paste type wax to the tables and
the fence so that the wood slides easily while feeding.
•
Keep blades sharp (see Sharpening Blades, page
9). Sometimes replacing blades is less expensive
than resurfacing them. Keeping a spare set of blades
on hand is recommended. Blades should always be
sharpened or replaced in sets of two.
LUBRICATION
WARNING:
Make sure the switch is in the OFF posi-
tion and the tool is disconnected from the power
source.
WARNING:
Do not at any time let brake fluids, gaso-
line, penetrating oils, etc. come in contact with plastic
parts. They contain chemicals that can damage and/or
destroy plastics.
•
Motor and cutterhead bearings are sealed and need
no lubrication.
•
Fence, fence bracket and elevation screws should
be cleaned of debris and greased as needed.
MACHINED
SURFACES
•
Surface of tables and fence must be kept smooth and
clean for easy work feed.
• Apply a paste wax to surfaces to keep them slick
and prevent corrosion.
BRUSH INSPECTION
AND REPLACEMENT
WARNING:
Turn jointer off and disconnect from power
source. Brush life depends on amount of load on motor.
Regularly inspect brushes after 100 hours of use.
Brushes are located on either side of motor.
Refer to Figure 25, page 16.
•
Loosen brush cap (Key No. 44) and remove brush (Key
No. 45) from motor.
•
Replace brushes if springs are worn.
•
Replace brushes if carbon is worn to 3/8"length or
less.
NOTE: Replace brushes in sets only.
•
Replace brushes and tighten brush cap.
11
Publicidad
