SUHNER ABRASIVE AMG 6-RL Documentación Técnica página 24

3.3.1 c /
hAnging fitting the grinding tool
Slide the tool into the provided tool holder until the stud
engages. Now check that the tool sits securely. After se-
curing the tool check that all external moving parts do
not collide with any stationary parts. Repeat this check at
regular intervals, replacing the tool when necessary.
3.4 w
orKing instructions
To achieve an optimum result, move tool uniformly back
and forth with light pressure. The electronic constant con-
trol maintains the speed nearly constant during idling and
work under load and assures a uniform result. Excessive
pressure lessens the working capability of the machine,
as well as the life of the tool. The machine is equipped
with an electronic control and integrated overload pro-
tection. If the machine is overloaded, the speed will drop
drastically. Immediately take the load off the machine and
allow to run for a short time without load.
4. S
ERvICE
4.1 P
reVentiVe mAintenAnce
To work effectively and securely
keep the machine and the ventila-
tion slots clean at all times.
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective insula-
tion of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a vac-
uum cleaner or by blowing in dry air. Prior to this opera-
tion, separate the power tool from the power source and
wear protective glasses and dust mask.
Clean the dust filter regularly: remove and clean with a jet
of compressed air.
Remove the battery pack periodically and wipe the con-
tact area of the battery pack and machine with a dry cloth
and remove deposits.
24
/ m
aINTENaNCE
4.2 t
rouBleshooting
Electronic signal display
p
roBlem
The battery pack is empty; the
temperature is too high or the restart
protection has triggered. Switch the
The electronic
machine off and back on again.
signal display
flashes and the The machine will not start if the
machine does battery pack is inserted while the
not start. machine is on.
When using a battery pack that is not
part of CAS, the machine will not
There has been an overload while
working, therefore the performance
may be reduced temporarily. Reduce
working pressure.
Electronic safety shutdown: the
machine has SHUT DOWN by itself. If
The electronic
signal display is the slew rate of the current is too high
permanently on.
(for example, if the machine sudden-
ly seizes or kickback occurs), the
machine switches off. Switch off the
machine. Switch it on again and con-
tinue to work as normal. Try to prevent
the machine from seizing.
4.3 r
ePAir
If the machine strict observance of the manufacturing and
testing method the tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the machine is returned in the undisassem-
bled condition.
t
roUBleshootinG
start.