Teka MDB-600 Manual De Instrucciones página 10

Dear Customer,
Congratulations on your choice. We are
certain that this modern, functional and
practical device made with first rate qua­
lity materials will fully satisfy your require­
ments.
Please read all the sections in this INS­
TRUCTION MANUAL before using the
hood for the first time in order to obtain
maximum performance from the device
and avoid faults which may arise from inco­
rrect use as well as minor problem solving.
For optimal performance, the external duct
should not exceed FOUR METRES, have
more than two 90 ° angles and its diameter
should be at least Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the in­
terior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
grease in the hood and metal fil­
ters may cause dripping and fire
risks, therefore it is necessary to
wash the inside of the hood and
the metal filters at least once a
month.
•This device can be used by
children aged 8 and over and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowled­
ge, if they have been given su­
pervision or proper training in
the safe use of the device and if
they understand the dangers in­
volved. Children should not play
with the device. Cleaning and
maintenance should be perfor­
med by the user and not by un­
supervised children.
•Check that the power voltage
and frequency match those in­
dicated on the label located on
the inside of the hood. A suitable
earth must be connected (except
for Class II devices, marked with
on the technical data plate).
•For installation, a connection
method isolated from the fixed
installation should be incorpora­
ted, in accordance with installa­
tion regulations (adjusted to the
strength to be endured and with
a minimum opening between the
contacts of 3mm) under over­
voltage category III conditions,
for the emergency shutdown,
cleaning or light replacement. In
no event should the earth pass
through this switch. This switch
can be replaced with a plug if it is
accessible in normal use.
•If the power lead is damaged it
must be replaced by the manu­
facturer, its after­sales service or
by qualified personnel in order to
avoid potential danger.
•Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or