Publicidad
Idiomas disponibles
Idiomas disponibles
Reassembling
the freezer
door (DRAWER TYPE - RF217,RF197)
1. Pull out the rails to the full length
on each sidle of the cabinet
evenly.
2. Hang the freezer door front onto
open slot on the sides.
3. With the 10mm wrench,
reattach
4 bolts to connect
the rail with
the door.
4. With the drawer pulled out fully,
insert the drawer box into the rail
system.
Reassembling
the freezer
door (SWING TYPE - RF195)
1. Place the hole in the bottom
of
the freezer door over the right
side low hinge.
2. Replace the middle hinge connected
to the freezer.
3. Insert and tighten the screw into the left and right middle hinges with a
philips screwdriver(+).
Insert and tighten the 2 hex head bolts into the
left and right middle hinges with an allen wrench(3!16").
4. Replace the cap on the middle hinge.
14 settiqg up
Publicidad
