Midea MBON5M90E5-BK Manual De Instrucciones página 16

Native appliance
583
EN
1. The thickness of the cabinet board is 20 mm.
2. If the power socket is installed on the back of the appliance, the depth of the
cupboard opening shall be increased from a minimum of 590 mm to 620 mm.
3. The dimensions in the figures are in mm.
Installation Important Instructions
Content that means [mandatory]
1. The safe operation of this appliance can only be guaranteed if it has been installed to
a professional standard in accordance with these installation instructions. The installer
shall be liable for any damage resulting from incorrect installation.
2. The entire installation process requires two professional installers. Wear dry protective
gloves during installation to avoid scratch or electric shock.
3. Fitted units must be heat-resistant up to 90°C, and adjacent unit fronts up to 70°C.
4. Please use a 16A socket.
Content that means [prohibit]
1. Do not install the appliance behind a decorative door or the door of a kitchen unit, as
this may cause the appliance to overheat.
2. Check the appliance for damage after unpacking it. Do not connect the appliance if it
has been damaged in transit.
3. Do not block the vent of the appliance and the gap between the cupboard and the
appliance.
4. Use extreme caution when moving or installing the appliance. It is very heavy, do not
lift the appliance by the door handle.
5. If the power cord or power plug is damaged, stop using the appliance immediately, to
avoid fire, electric shock or other injuries.
Hob
With hob
If the appliance is installed under the hob,
the minimum thickness of worktop A is
A
shown below:
5
Hob type
Induction hob
Full-surface
induction hob
Gas hob
Electric hob
5
EN-13
worktop A
37 mm
47 mm
30 mm
27 mm