AKO Sun Power S250 Manual De Instrucciones página 12

Installation instructions
and use of the energiser
AKO Sun Power S250
Battery charging
3. Important information about the 12-volt battery
When the battery is no longer in use (winter storage), store it in a clean, dry, well-ventilated place where the temperature is around 20°C.
Always fully charge the 12-volt battery before prolonged storage to optimise its life (one full day without interruption). We strongly
recommend recharging the battery every 3 months or more during storage to maintain a charge rate close to 100% and avoid deep
discharges (voltage below 11.8 Volts).
We also recommend that you disconnect the cables connecting the energiser to the battery and replace the white PVC terminals on the 12-
volt battery terminals. This will limit self-discharge and prevent accidental short-circuits.
Recharge the battery for a full day without interruption before putting it into service. When the appliance is in use, we advise you to fully
charge it once a month using the charger to optimise the life of the battery. If you follow these instructions, the battery should last between
3 and 4 years.
4. Fitting the 12-volt battery
Battery charged
Kerbl France - www.kerbl.fr
Once connected, a flashing red LED
will indicate that the 12-volt battery is
being charged.
When charging is complete, the green
LED will remain steady.
We recommend that you leave the
charger connected to the 12-volt
battery for at least 12 consecutive
hours when charging for the first time.
Once the 12-volt battery is fully charged,
install it in the Sun Po- wer S250 energiser.
Make sure the switch is in the
"Then connect the power cables.
Connect the "+" (red) and "-" (black) terminals
of the energiser to the battery.
Replace the protective cover and tighten the
screw by hand.
EN
11