Publicidad
IMPORTANT! KEEP FOR FUTURE REFERENCE!
EN
READ CAREFULLY!
3 POINT VEHICLE BELT + ISOFIX
1) Release the buckle tongue from the vehicle seat buckle. Unthread 3-point vehicle belt from the child car seat and allow it to retract.
2) Press the ISOFIX release buttons to release the ISOFIX connectors, push the ISOFIX connectors back into the base of the child restraint.
3) Remove the child car seat from the vehicle seat.
V. REMOVAL AND INSTALLATION OF THE 5 POINT HARNESS
5.1-5.6 Removal of the 5-point harness
1) Press down on the central adjuster, and pull the shoulder straps towards you, extending the 5-point hamess as far as it will go. DO NOT pull on the shoulder pads.
2) Pull the adjusting handle upwards, whilst pushing the headrest downwards to suitable position. Turn the child car seat around so that the rear is facing you.
3) Open the rear cover board.
4) Place the webbing loops of the shoulder straps over the joint plate.
5) Close the rear cover board. Turn the child car seat around so that the front is facing you.
6) Pull out the shoulder belts and shoulder pads from the headrest slots in front of the headrest.
7) Take out the shoulder belts from the buckle.
8) Turn the metal plate to be vertical and remove from the housing, remove the 5-point harness buckle.
5.7-5.12 Installation of the 5-point harness
1) Place the 5-point harness buckle into the crotch pad.
2) Turn the metal plate of the 5-point harness buckle to be vertical and insert it into the housing.
3) Guide the two buckle latches together and insert them into the 5-point harness buckle. An audible "click"will be heard once the buckle is locked.
4) Pull the adjusting handle upwards, whilst pushing the headrest upwards until holes are aligned.
5) Thread both of the shoulder belts through the shoulder pads.
6) Thread the loops of both shoulder belts and shoulder pads through the headrest slots. The straps of the shoulder pads should be beneath the straps of shoulder belt. Turn the child
car seat around so that the rear is facing you.
7) Open the rear cover board.
8) Place the webbing loops of the shoulder straps over the joint plate.
9) Close the rear cover board.
VI. CARE AND MAINTENANCE
Care for the 5-point harness buckle: Buckle failure can cause injury. DO NOT use oil or other lubricants on any part of the 5-point harness buckle. Buckle malfunctions are usually caused
by a build-up of debris such as food crumbs or other small particles.
Signs of buckle malfunction as below:
•
The buckle latches are slow to release when the red release button is pressed.
•
The buckle latches will not lock into the buckle securely (i.e they are ejected again if you try to push them in).
•
The buckle latches engage without an audible "click".
•
The buckle latches are di cult to insert (you will feel resistance).
•
The buckle opens ONLY when extreme force is applied.
To wash the harness buckle so that it functions as required:
Step 1: Remove the 5-point harness buckle from the child car seat.
Step 2: Soak the 5-point harness buckle in warm water with mild washing-up liquid for at least an hour. Rinse and allow it to air dry thoroughly before attaching back onto the child car
seat.
Produced for Kikka Group Ltd., Vasil Levski 121, Plovdiv, Bulgaria. Made in China.
Complies with EN R129.
ENGLISH
Publicidad
