Jackery Explorer 880 Pro Manual página 7

US
Charging from the wall
Please use the AC cable included in the package.
Solar energy charging
AC Charger Explorer 880 Pro
Jackery SolarSaga 200 or 100 or 80 Solar Panel Connection Guide
If one or two solar panels are connected, you can directly connect the DC8020 port of the solar
panel to the DC8020 port of Jackery Explorer 880 Pro for charging. If four solar panels are connect-
ed, please refer to the method shown in the following figure to charge through the solar series
connector (Note: The solar series connector is not in standard configuration, so you need to purchase
it separately. Please refer to the detailed operation instructions of the solar series connector before
using it.)
Solar series connector
SolarSaga×2 Explorer 880 Pro
Solar series connector Solar series connector
SolarSaga×2 Explorer 880 Pro SolarSaga×2
Tip: Jackery Explorer 880 Pro does not support three Jackery SolarSaga 200 or 100 or 80 solar
panels in single input; otherwise, over-voltage protection will be triggered.
Jackery SolarSaga 80 Solar Panel Connection Guide
Users who have purchased Jackery SolarSaga 80 can charge the product by referring to the
connection mode shown below. The Jackery SolarSaga 80 supports the parallel connection or the
parallel and then series connections to charge the product. The single input port of the Jackery
Explorer 880 Pro supports the input of up to six pieces of SolarSaga 80 solar panels, and two input
ports support the input to up to 6 pieces of SolarSaga 80 solar panels. (When the power is
connected with six solar panels in a single input port, the solar panels shall be divided into two
groups, and each group of three solar panels shall be self-connected in parallel and then connected
to Jackery Explorer 880 Pro through the solar series connector. The solar series connector needs to
be purchased separately.)
For detailed operation instructions on the self-parallel connection of the Jackery SolarSaga 80 solar
panel, please refer to the user manual.
05