Glow Fire Inside 106 Instrucciones De Montaje página 12

FLAME button: Makes flame effect dimmer
and brighter.
NOTE: Flame effect stays on until power
button is turned off. Flame effect must be on
for heater to turn on.
FLAME
COLOR button: Makes the color flame effect
changing.
NOTE: color effect stays on until power button
is turned off. Color flame effect must be on for
heater to turn on.
COLOR
NOTE: this fireplace is with memory function
for flame.
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: Heater button can be locked or
unlocked by holding the Heater button for 5
HEATER
seconds.
Flame speed button:Controls the speed of
the flame.There are 3 flame speed settings: 01
(slowest), 02 (Medium), 03 (fastest).
SPEED
When the heater is first turned on, a slight odor may be present. This is normal and should
NOTICE
not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT press
NOTICE
the buttons too quickly. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature,
the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a
vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
Remote control uses one CR2025 battery (Included)

NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
Glow Fire GmbH, James-Franck-Straße 23, 12489 Berlin
1. Press once. Flame brightness effect gets
changing.
2. Press again. until desired setting is reached.
1. Press once. Flame color effect gets
changing.
2. Press again until desired setting is reached.
In total with 10 color flames.
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
1. Press once. Flame speed gets changing.
2. Press again until desired setting is reached.
Display shows the setting.
The Default setting is 03 (fastest speed)
12