Würth H 24-MLS Instrucciones Para El Manejo página 13

0702 225X - GB Seite 12 Freitag, 23. Januar 2004 12:54 12
Tool Specifications
Rotary Hammer
Order number
Rated power
Output power
Speed control
Right/Left rotation
Rated speed
- Right rotation
- Left rotation
Impact rate
Impact energy per stroke
Tool holder
Spindle collar diameter Ø
Chisel positions
Drilling output:
- Masonry (core bit), max.
- Stone, Concrete, max.
- Wood, max.
- Steel, max.
Weight (without accessories),
approx.
Protection class
Operating Controls
1 Keyless chuck
2 Dust protection cap
3 Locking sleeve
4 Interlock
5 Lock-on button for On /Off switch
6 On/Off switch
7 Rotational direction switch
8 Release button
9 Mode selector switch
10 Auxiliary handle
11 Depth stop
12 Clamping sleeve
13 Knurled ring
Not all of the accessories illustrated or described are included
as standard delivery.
12
The machine is intended for hammer drilling in con-
H 24-MLS
crete, brick and stone. It is also suitable for light cor-
0702 225 X
rective chiselling work as well as for drilling without
680 W
impact in wood, metal, ceramic and plastic.
390 W
The user is responsible for damage caused by usage
other then intended.
0 – 870 rpm
0 – 500 rpm
Before any work on the machine itself, pull the
0 – 4 850 bpm
mains plug.
2.4 J
With the SDS-plus tool holder, simpler and easier
SDS-plus
tool changing is possible without additional aids.
43 mm
The dust protection cap 2 largely prevents the entry
36
of drilling dust during operation. When inserting the
tool, take care that the dust protection cap 2 is not
damaged.
68 mm
24 mm
30 mm
13 mm
2.4 kg
/ II
Inserting (see figure A)
Clean and grease the shank end of the tool.
Insert the tool in a twisting manner into the tool
holder until it locks. Check if it has locked by pulling
the tool.
Removing (see figure B)
Push back the locking sleeve 3 of the tool holder and
remove the tool.
Keyless Chuck for Tools with a
The SDS-plus tool holder can easily be replaced by
the keyless chuck 1 supplied with the machine. The
keyless chuck serves for rapid insertion of the tools
without the SDS-plus (e. g. round shaft drill, screw-
driver bits).
Before any work on the machine itself, pull the
mains plug.
Do not hold the machine by the chuck!
The keyless chuck is not suitable for hammer
drilling.
Intended Use
Changing the Tool
As a requirement of the system, the SDS-plus
tool must rotate freely. At no-load speed, this
leads to a certain amount of radial run-out.
This does not affect the accuracy of the drill
hole, as the bit is automatically centred during
drilling.
Cylindrical Shaft