Installation; Setting Up - How To Set The Battery Or Ac-Dc Power Adaptor - Geemarc V2T-10 Manual De Uso

INSTALLATION

Setting Up – How to set the battery or AC-
DC power Adaptor
Open the battery compartment by pressing the small plastic
lock on battery cover (1) located on the rear of the V2T-10
Piece. Insert the supplied battery (9V PP3) into the battery
compartment (2), and then replace the battery cover.
NOTE: Insert battery with the correct polarity as shown
in the battery compartment.
A 9V AC-DC Power Adaptor (not included) can be used to
power the V2T-10 unit.
Plug the Power Adaptor into the mains supply and plug the
other end of the lead into the DC Power Supply Port (3)
( ) on the right hand side of the V2T-10. Switch the
mains supply on.
NOTE: Make sure the correct polarity of Adaptor output
plug, centre is "+".
5