Publicidad
Idiomas disponibles
Idiomas disponibles
Peo Tm]
2a
(power H standby © = on)
"Power-through" function
Discs, radio broadcasts, etc. can be heard even if the
power of this unit is switched to standby.
(equalizer level control)
(memo mode)
This button is used to select the equalization memory mode to
be used.
originally pre-programmed to the unit's memory.
Memory button (memory)
This button is used to program the equalization curve into the
memory.
[6]
Reverse button (reverse)
This button is used to reverse the equalization curve shown in
the display.
Display mode-select buttons
(display mode)
—
These
buttons are used to select the equalization-level
display mode and any of the three types of spectrum display
mode described below.
@ Equalization-level display mode
EQ level:
Select this mode when you want to display the
equalization level.
m@ Spectrum display modes
(spectrum analyzer)
bar:
Select this mode when you want a bar-type
display.
dot:
Select this mode when you want a dot-type
display.
peak hold:
Select this mode when you want the peak to
be held in the display.
Preset-memory buttons ([1]-[6]))
-
These buttons are used to program an equalization curve into
the memory, or to retrieve a curve originally programmed into
the unit's memory.
Recording mode selector
(EQ rec HL off = on)
on:
Set to this position to make a tape recording of a radio
broadcast or a disc while controlling the frequency
response.
off:
Set to this position to record without equalizer correc-
tion.
Input selector (I source m tape)
source:
Set to this position to listen to the radio or a
compact disc, etc.
Set
to this
position
to listen
to a tape
deck
connected to the back of this unit.
tape:
Publicidad
