Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING THE UNIT
Chopper configuration.
1)
Fit the container (3) properly into the main body (6) by turning it into place until it snaps.
2)
Insert the rostrum (5) in the container without touching the blades.
3)
Insert the food without exceeding the maximum capacity (400cc).
4)
Fit the lid (4) properly over the container (3), by turning clockwise until it clicks in position. Plug the
unit and push the operation button to turn it on.
Slicer configuration.
1)
Fit the container (3) properly into the main body (6) by turning it into place until it snaps.
2)
Insert the speed reducer (11) in the container. This accessory reduces the speed rotation of the disk, in
order to have a precise cut.
3)
Mount the disk (10) on the reducer (11) without touching sharp parts. Insert the disk on the correct side:
one side slices, the other makes a julienne cut.
4)
Fit the slicer lid (7) properly over the container (3), by turning clockwise until it clicks in position.
Place a container under the food exit hole, on the left side of lid.
5)
Insert the food in the entry hole of lid and place the food presser (9).
6)
Plug the unit and push the operation button to turn it on. Food will come out from the exit hole,
dropping in the container continuously.
SAFETY BLOCK
This model has a double safety device: unit only works if the container (3) is placed correctly
into the main body (6) and the lid (4) is correctly inserted in the joint (8). Remove the lid and
the motor stops running. In this case, set the power button (1) to "0" and replace the lid.
FIRST USE
Removing and assembling the glass container a few times without plugging it or adding any fruits or
vegetables. Follow this step to practice with the appliance. Wash the lids and the jug with warm water and
dishwashing liquid. Other accessories made of electrical parts, such as the motor block and the main body
must be cleaned with a damp cloth and dry immediately.
GRINDING
The blade set consists of two blades that can chop and shred fruits, vegetables and meat; by adding liquids,
it's easy to prepare baby meals and homogenized food.
For a correct use follow the next steps:
- Pre-chop fruits and vegetables in small pieces and put them inside the container.
- If you want to prepare baby food or homogenized, add some water or milk not exceeding the maximum
capacity of the glass. Close the lid.
- Push and hold the power button until you reach the desired consistency of the food. At the end of the
process, power off the device and unplug it.
- Remove the container from the main body by gently pulling it up then pour the contents.
For best results it is recommended to process the foods at speed "1" (lower speed) first, then at the speed "2"
(high speed), making it possible to finely chop the food.
The PULSE button can be switched on for a machining pulse.
Meat
Fish
Onion
Garlic
Fruits
Carrot
Tomato
Cut in pieces of 1.5cm, add 3 spoons of water
Remove fishbone and cut in pieces of 2cm
Peel off and cut in pieces of 2-3 cm
Peel off
Peel off, remove pit and cut in pieces of 2 cm
Peel off and cut in pieces of 2 cm
Cut 4 pieces
250g max
30sec.
150g max
10-20sec.
100g max
7 pulses
5 pieces max
5sec.
150g max
10-15sec.
200g max
20sec.
100g max
10-15sec.
11
Publicidad
