Publicidad
Idiomas disponibles
Idiomas disponibles
DISPLAY
When you turn on the laser for the first time, it will take some seconds to auto load the built-in show. The
default setting is AUTO EFFECT 1.
First Menu
DMX512
AUTO
(Auto running mode)
Music
(Sound activate mode)
Setting
Testing
ONE BEAM PROTECTION
For safety reason you can switch the One Beam protection On/Off via display. If the One Beam is activated (ON) highly
focused single beam are suppressed. Switch to OFF to deactivate the One Beam protection.
This function should only be turned off by well-trained operator, after checking well all safety aspects!
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
Second Menu
Running
A001 (DMX address)
Running
Running
Address
Light
(LCD backlight setting)
Cartoon
(Running speed)
Master
(set master unit)
Laser
(size and colour setting)
One beam
Default
(restore default setting)
Testing picture
Third Menu
Effect 1 (Full show)
Effect 2 ( Only beam)
Effect 3 (only cartoon)
Effect 1 (Full show)
Effect 2 (only beam)
Effect 3 (only animation)
Choose DMX address
OFF
ON
ON 5S (ON for 5 sec)
ON 10S (ON for 10 sec)
Press "UP" and "DOWN" to
choose running speed from
1~99 (Slow to fast)
OFF
ON
Size
Colour
Invert X
Invert Y
OFF
ON
YES
NO
Fourth Menu
(Press "UP" or "DOWN" to
choose the size of graphics)
1. Single colour (1~7)
2. RGY
3. RBP
4. GBC
5. RGB
11
Publicidad
