Bosch Professional GGS 7 LC Manual Original página 22

OBJ_BUCH-247-004.book Page 22 Wednesday, July 21, 2010 9:59 AM
22 | English
The grinding tools must run completely concen-
trically. Do not continue to use damaged grind-
ing tools that are out of balance. If the grinding
tools are out of balance they should be re-
placed. Treat with a whetstone (accessory) or
change.
Using a whetstone, any particular special shape
can be produced out of the basic forms of the
grinding accessory.
Do not tighten the collet chuck of the
clamping nut as long as no grinding acces-
sory is mounted. Otherwise, the collet chuck
can become damaged.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Prevent dust accumulation at the work-
place. Dusts can easily ignite.
Operation
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
3 609 929 B98 | (21.7.10)
Switching On and Off
To start the power tool, push the On/Off switch
5 forwards.
To lock the On/Off switch 5, press the On/Off
switch 5 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 5 or, if it is locked, briefly push down the
back of the On/Off switch 5 and then release it.
Check grinding tools before using. The
grinding tool must be mounted properly
and be able to move freely. Carry out a test
run for at least one minute with no load. Do
not use damaged, out-of-centre or vibrating
grinding tools. Damaged grinding tools can
burst and cause injuries.
Constant Electronic Control
(GGS 7 C/GGS 27 LC)
Constant electronic control holds the speed
constant at no-load and under load, and ensures
uniform working performance.
Speed preselection (GGS 7 C/GGS 27 LC)
The required speed can be preselected with the
thumbwheel 6 (also while running).
The required speed depends on the material to
be worked and the diameter of the tool. Deter-
mine the optimum setting through practical
testing.
Thumbwheel No-load speed (min
Position
GGS 7 C
1 3100
2 4150
3 5450
4 6200
5 6700
6 7000
-1
)
GGS 27 LC
12000
16000
21000
24000
26000
27000
Bosch Power Tools