HAMPTON BAY HD7133A Guía De Uso Y Mantenimiento página 5

Installation
1
Installing the crossbar assembly
□
Secure the crossbar assembly (AA) to the outlet box (not
included) with the outlet box screws (BB). Tighten until
snug.
NOTE: The preassembled mounting screws on the
crossbar should protrude outward.
Outlet box
3
Making the electrical connections
* Use wire connectors (CC) to connect the wires.
□
Ground Wire:
□
Wrap the supply ground wire around the green ground screw on
the crossbar assembly (AA), no less than 2 in. from the end of the
wire. Tighten the ground screw.
□
Connect the fixture ground wire to the supply ground wire with a
wire connector (CC).
□
Supply Wire:
□
Connect the supply white wire to the white fixture supply wire
with a wire connector (CC).
□
Connect the supply black (or red) wire to the black fixture supply
wire with a wire connector (CC).
□
Wrap each connection with approved electrical tape and carefully
insert all of the connected wires into the outlet box.
2
□
Unscrew the two mounting balls (1) from the crossbar
assembly (AA).
□
Fit the ceiling canopy of the fixture body (A) to the crossbar
assembly (AA) and secure with the mounting balls (1).
□
If they do not align, adjust the length of the mounting
screws on the crossbar assembly (AA) by unscrewing the
preassembled hex nuts.
□
Screw the mounting screws in or out of the crossbar until
the desired length is achieved.
□
Once the fixture body (A) is secure, remove the mounting
balls (1) and the fixture body (A) and proceed to Step 3.
AA
BB
5
Testing the ceiling canopy fit to the
crossbar assembly
NOTE: The ceiling canopy should be snug against the
ceiling and the mounting balls (1).
AA
A
1
AA
Please contact 1-855-HD-HAMPTON for further assistance.
CC
Green ground screw
HAMPTONBAY.COM