Generac Portable P roducts 2,500 PSI H igh Pressure Washer
• Move the choke lever to the "Closed" position
(Figure 15).
Closed
/
NOTE: For a warm engine, be sure the choke lever is in
the "Open"
position.
Set the engine switch to the "On" position (Figure 16).
Engine Switch
.off
Grasp starter grip and pull slowly until you feel some
resistance. Then pull cord out with rapid full arm stroke.
Let rope return slowly. Do Not let rope "snap back"
against
starter.
• If the choke lever has been moved to the "Closed"
position to start the engine, gradually move it to the
"Open"
position
as
the
eng{ne warms
up.
NOTE:
If the recoil starter is hard to pull, it may be
necessary
to
squeeze
the
gun
trigger to
tel{eve
internal
pump pressure.
How to Stop Your
Pressure
Washer
• Move the throttle
lever to the "Slow"
position.
• Wait for the engine to idle down.
• Move the engine switch to the "Off'
position.
• Simply shutting off the engine will not release pressure in
the system. Squeeze trigger on the spray gun to
relieve pressure in the hose.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension
and quick connect nozzles, and
slots to hold the cleaning solution
bottle and the detergent
siphoning filter. There are also two hooks on the handle to
hold your spray gun and high pressure hose.
NOTE:
The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle
extension
through the hole on the
accessory
tray as shown in Figure 17.
Hang your chemical solution bottle on the "J" hook and
place the detergent siphoning filter in the last slot on the
left (Figure 17).
• Place the spray gun on the hook attached to the handle
on the right side of the unit (Figure 17).
• Hang the high pressure hose on the hook attached to
the handle on the left side of the unit as shown on
page 4.
/
9