Elta KME-900.15TS Manual De Instrucciones página 15

let it cool down. When it is cold enough, repeat the process with
fresh water. Repeat this process 3 �mes.
USING YOUR COFFEE MAKER
1. Open the water tank lid and fill the water tank with cold drinking
water. The water level should not exceed MAX level as indicated on
water gauge.
2. Open the lid, put the funnel into funnel holder, then place the filter
paper in the funnel, and make sure it is assembled correctly.
3. Add proper coffee powder into filter. Usually a cup of coffee need a
level spoon of coffee powder, but you may adjust according to
personal taste, and then close the Lid
4. Insert the carafe on warming plate horizontally.
5. Plug the power cord into the outlet. The LCD will display
"12:00" and the colon will flash, but all the bu�on lights will
not illuminate.
6. Press ON/OFF bu�on, the indicator of RUN will be
illuminated red. The appliance will begin working.
7. The brewing process can be interrupted by pressing the ON/OFF
bu�on twice again at any �me, and the indicator of RUN will be
ex�nguished. The appliance will con�nue brewing once ON/OFF is
pressed again.
Note: You can take out carafe, pour and serve at any �me.
The appliance will stop dripping automa�cally. But the �me
cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing (about one minute
later a�er the coffee stops dripping out.)
9. When the process is finished, if you do not want to serve
immediately, keep the coffee maker is energized, the coffee can be
kept warm in the warming plate. The appliance will be cut off power
automa�cally a�er 40 mins if it has not been manually disconnected
at the comple�on of brewing.
10. Always turn the coffee maker off and disconnect the power supply
when not use.
15