Dometic TD283 Guía De Instalación Y Funcionamiento página 10

Pos. in A Compo- Description
nent
8 Cleaning and maintenance
NOTICE! Damage hazard
• Do not use abrasive cleaning agents or hard objects during cleaning as these may damage
the device.
• Do not use cleaning agents that contain ammonia or alcohol.
• Never spray or pour liquid directly onto the touchscreen or casing.
8
Solar charge controller menu
The following is displayed (see Fig. , C):
• Current value for voltage (in V) of the starting battery (1)
Hist.
• Open for an overview of the solar energy delivered over the last 3 weeks.
(2)
• Daily output (in Wh) of connected solar panels (3)
• Status of the solar charge controller (Standby/MPPT/Absorption/Float/Off) (4)
• State of charge of the house battery (circle diagram in 5/25 % steps) with current
values for voltage (in V) and current (in A) (5)
Battery charger menu
The following is displayed (see Fig. , D):
• Status of the battery charger (Standby/Bulk/Absorption/Float/Off) (1)
• Voltage (in V) of the starting battery (2)
• State of charge of the house battery (circle diagram in 5/25 % steps) with current
values for voltage (in V) and current (in A) (3)
House battery menu
The following is displayed (see Fig. , E):
• Status of the battery (On/Off) and time to full charge/discharge (1)
• Battery capacity in Wh (2)
• Battery condition (maximum capacity in %) (3)
• Analysis of the battery temperature (OK, High or Low) (4)
• State of charge of the house battery (in %) with current values for voltage (in V) and
current (in A) (5)
• If more than one battery is connected in the N-BUS network: Open
overview of the individual battery condition and battery temperature for up to 4
batteries in the network (not shown)
Inverter menu
The following is displayed (see Fig. , F):
• Status of the inverter (On/Off) (1)
• Maximum surge power (in W) and current output voltage (2)
• State of charge of the house battery (in %) with current value for voltage (in V) (3)
Hist.
for an