Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the STRIKE Array 1.
•
The luminaire is intended for professional use only.
•
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
7.5 ft (2.3 m) is not expected.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or its service agent.
•
The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or
a similar qualified person.
•
CAUTION:
•
This product's housing may be hot when operating. Mount this product in a location with adequate
ventilation, at least 20 in (50 cm) from adjacent surfaces.
•
When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
•
Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding notification
of strobe use.
•
ALWAYS:
•
Disconnect from power before cleaning the product.
•
When using an IP65-rated product in an outdoor environment, use IP65- (or higher) rated power and data
cable.
•
Replace and secure IP-rated protective covers to all power, data, USB, or other ports when not in use.
•
Use a safety cable when mounting this product overhead.
•
Connect this product to a grounded and protected circuit.
•
DO NOT:
•
Open this product. It contains no user-serviceable parts.
•
Look at the light source when the product is on.
•
Leave any flammable material within 50 cm of this product while operating or connected to power.
•
Connect this product to a dimmer or rheostat.
•
Operate this product if the housing, lenses, or cables appear damaged.
•
Submerge this product (adhere to standards for the published IP rating). Regular outdoor operation is fine.
•
Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not
limited to:
•
Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
•
Locations where normal temperatures exceed the temperature ranges in this manual.
•
Locations that are prone to flooding or being buried in snow.
•
Other areas where the product will be subject to extreme radiation or caustic substances.
•
ONLY use the hanging/mounting bracket to carry this product.
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
•
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
•
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
•
In the event of a serious operating problem, stop using immediately.
1
QUICK REFERENCE GUIDE
STRIKE Array 1 QRG Rev. 3
Publicidad
