Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
IMPORTANT:For best performance,keep
lawn mowerhousingfree of built-grassand
trash. Cleanthe undersideof your lawn
moweraftereach use.
,_I,CAUTION:
Disconnect
spark plug wire
from spark plug and place wire where
it
cannot
come in contact
with plug.
• Clean
the underside
of your
mower
by
scraping to remove build-up of grass/trash.
• Clean engine
often to keep trash from
accumulating.
A clogged
engine
runs
hotter and shortens
engine
life.
• Keep finished
surfaces
and wheels
free
of all gasoline,
oil, etc.
• We do not recommend
using a garden
hose to clean lawn mower
unless the
electrical
system,
muffler, air filter and
carburetor
are covered
to keep water
out.
Water
in engine
can result in short-
ened engine
life.
CLEAN
UNDER
DRIVE
COVER
Clean
under drive cover at least twice a
season.
Scrape
underside
of cover with
putty knife or similar tool to remove
any
build-up
of trash or grass on underside
of
drive cover.
_I_WARNING:
To avoid serious injury, before
performing
any service
or adjustments:
1.
Release
control
bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come
in contact
with plug.
LAWN
MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST
CUTTING
HEIGHT"
in
the Operation
section
of this manual.
REAR
DEFLECTOR
The rear deflector, attached
between the rear
wheels of your mower, is provided to minimize
the possibility
that objects
will be thrown
out
of the rear of the mower
into the operator's
mowing
position.
If the deflector
becomes
damaged,
it should
be replaced.
DISCHARGE
GUARD
The discharge
guard,
attached
to the
discharge
opening
of your lawn mower,
is
provided
to prevent
the possibility
of injury
resulting
from objects
being thrown
out of
the discharge
opening
into the operator
mowing
position.
If the discharge
guard
becomes
damaged,
it should
be replaced.
TO REMOVE
DRIVE
BELT
1.
Remove
drive cover.
2.
Remove
belt from gearcase
pulley by
pushing
down on arm and rolling belt
off pulley.
3.
Turn lawn mower
on its side with air
filter and carburetor
down.
4.
Remove
blade, engine
pulley and
debris
shield.
5.
Remove
engine
pulley
and belt from
debris
shield.
PUSH
Drive
cover
Pulle_
Engine pulley
Drive belt
Belt
retainer
Debris shield
14
Publicidad
