VEVOR AY450-1 Manual De Instrucciones página 4

There are three specifications for the blade components of this product,
3/16, 3/8, 1/4, and two types of thrusters: 3/16, 3/8. The machine is
equipped with a 3/16 thruster by default.
When replacing the 3/16 or 3/8 blade assembly, there is no need to replace
the thrusters. 3/16 and 3/8 can be used together. Replace the blade by
using the provided wrench to remove the screws that fix the blade (as
shown in Figures 1, 2, 3, and 4), remove the blade, and then install the
blade that needs to be replaced.
When replacing the 1/4 blade assembly, the 3/16 thruster needs to be
removed (as shown in Figure 5, 6 screws can be removed). The gasket (as
a gift) needs to be replaced and adjusted until it does not touch the blade
before it can be replaced
Replacing the thruster gasket:
Remove the screws from the original 3/16 thruster, remove the aluminum
plate and gasket in sequence, and then replace the 3/16 gasket with 1/4 of
the gasket (as a gift) in the order of one gasket and one aluminum plate.
After replacing the gasket, install it on the machine to test whether the
thruster has touched the blade assembly. If there is any contact or friction,
adjust the gasket sequence until there is no friction between the thruster
and the blade assembly before use.
CLEANING:
1. The pusher assembly can be removed from the slide board by removing
the thumb screws from the end of the slide
board.
2. Once removed spray down the components to remove all debris and
remaining food product.
3. The equipment can also be washed in a sink using a mild detergent.
Rinse equipment thoroughly after washing.
4. Allow equipment to air dry.
NOTE: If using hot water to clean the equipment, it may be necessary to
rinse the equipment with cold or warm water. Hot water may cause the
- 3 -