Descargar Imprimir esta página

Craftsman 917.378030 Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

CYLINDER
1. Remove spark plug.
2. Pour one ounce (29 ml) of oil tl,,Ju.gh
spark plug hole into cylinder.
3. Pull starter handle slowly a few times
to distribute oil.
4.
Replace with new spark plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline
will cause problems.
• If po,_ihlr,
'_t._re your unit indoors and
€,_,_,_';4 -I-_ _; J_i it from ,_-_>'/- , ,._..l_.,rt.
• ¢___.e_. _¥
with a -_;€_
_#otec-
rive cover that does not retain moisture.
Do not use plastic.
Plastic cannot
breathe, which allows condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust areas are still warm.
ACAUTION:
Never store the lawn
mower with gasoline in the tank inside a
building where fumes may reach an open
flame or spark.
Allow the engine to cool
before storing in any enclosure.
TROUBLESHOOTING
- See appropriate
section in manual unless directed
to a Sears Service Center.
PROBLEM
CORRECTION
Does not start
Loss of power
CAUSE
1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control
bar in released
position.
9. Control bar defective.
1. Rear of lawn mower
housing or cutting blade
dragging
in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Clean/replace
air filter.
2. Fill fuel tank.
3. Drain tank and refill with
fresh, clean fuel.
4. Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter.
8. Depress control bar to
handle.
9. Replace control bar.
1. Set to "Higher Cut"
position.
2. Set to "Higher Cut"
position.
3. Clean/replace
air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
16

Publicidad

loading