1. SAFETY PRECAUTIONS
Also see installation manual attached to the indoor unit.
• Please read the "Safety Precaution" carefully before operating the unit to ensure correct usage of the unit.
• Pay special attention to signs of "
may cause death or serious injury. The "Caution" section contains matters which may result in serious consequences if not observed properly.
Please observe all instructions strictly to ensure safety.
• Be sure that the unit operates in proper condition after installation. Explain to customer the proper operation and maintenance of the unit as
described in the user' s guide. Ask a customer to keep this installation manual together with the instruction manual.
• Please request your sales agent or qualified technician to install your remote controller. Short circuit or fire may occur if you do the installation
work yourself.
• Do not pour water into the remote controller. This product is equipped with electrical parts. If poured, it will cause a serious electrical shock.
• Please observe the installation stated in the installation manual during the process of installation. Improper installation may cause electric
shock and fire.
• Please contact your agent for maintenance. Improper self maintenance may cause electric shock and fire.
• Please contact your agent if you need to remove and reinstall the remote controller. Electric shock or fire may occur if you remove and reinstall
the remote controller yourself improperly.
• Make sure that the remote controller is mounted at locations which is able to provide full support to the weight of the remote controller. If
not, the remote controller may collapse and impose danger.
• Use specified cables to connect between indoor unit and remote controller. Selecting incorrect cables may lead to fire or electrical shock.
• Should abnormal situation arise (like burning smell), please stop operating the unit and turn off the circuit breaker. Contact your agent. Fault,
short circuit or fire may occur if you continue to operate the unit under abnormal situation.
• Always perform installation work with turn off the circuit breaker. Touch with energized electric parts causes an electric shock.
• The sales agent and qualified technician shall comply with local regulations or standards for the safety.
• Do not install the remote controller and cable at such places as;
- Where there is oil vapor and the oil is dispersed.
- Where the hot springs are near (in a sulfuric environment).
- Where generation, flowing, staying or leaking of flammable gas is detected.
- Where the sea is near (in the salty environment).
- An acid or alkaline environment.
• Do not install the indoor unit, outdoor unit, remote controller and cable within approximately 3 meters from strong electromagnetic wave
radiators such as medical equipment. In case that the remote controller is installed in a place where there is electromagnetic wave radiation,
shield the remote controller and cables by covering with the steel box and running the cable through the metal conduit tube.
• To avoid noise interference, please place the indoor unit and remote controller at least 1m away from TV/radio.
• This appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction. Children must be supervised not to play with the appliance.
2. INSTALLATION WORK
2.1 SELECTION OF INSTALLATION PLACE
Select a suitable place for handling and determine the installation place of the controller with the customer's acceptance.
Do not install the controller at such places as:
- Where children can touch.
- Where the air from the air conditioner is directly discharged.
Especially in case that a Remote Controller thermostat is used, select the installation place in consideration with the following points:
- Where the average room temperature is detectable.
- Where the thermostat is not exposed directly to the sun.
- Where there is no source of heat.
- Where the thermostat is not affected with the outdoor air by opening and closing doors.
Prior to the installation work, ensure that foundation is flat, level and sufficiently strong and then fix the unit securely. If the foundation is not
strong enough, it may lead to injuries caused by falling of the product, electrical shock or fire.
2.2 BEFORE INSTALLATION
Check the contents and the number of the accessories in the packing.
Remote controller for
operation control
Warning" and "
Caution". The "Warning" section contains matters which, if not observed strictly,
2 screws M4x16L for
Connecting cable
fixing the holding
bracket onto the wall
WARNING
CAUTION
Manual CD
- 2 -
Installation manual
(This manual)