Descargar Imprimir esta página

Powerplus POWDP7080 Traduccion Del Manual De Instrucciones Originale página 33

Ocultar thumbs Ver también para POWDP7080:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 51
When disposing of batteries, follow the instructions given in the section "Protecting the
environment".
Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
 Carefully wipe the liquid off using a cloth. Avoid skin contact.
 In case of skin or eye contact, follow the instructions below:
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2
Chargers
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
8 OPERATION
8.1
Charging the battery pack
The battery pack for this tool is supplied in a low charge condition to prevent possible problems,
therefore, you have to charge the battery before first use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not indicate
a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room temperature.
When the battery becomes fully charged, unplug your charger from the power supply and
remove the battery pack from the charger.
Note:
Allow the battery pack to cool completely before charging
Inspect the battery pack before charging, do not charge a cracked or leaking battery pack.
Copyright © 2019 VARO NV
POWDP7080
P a g e
| 6
EN
www.varo.com

Publicidad

loading