Adler europe AD 8085 Manual De Uso página 5

current not exceeding 30 mA. A specialist electrician should be consulted in this regard.
15. Only original assembly parts and power cables supplied by the manufacturer in the set
with the device should be used.
16.Do not overload the refrigerator. The cover must close freely.
17. WARNING: Be careful that the products stored inside do not cover the vent.
18. Use the refrigerator in an upright position only.
19. Do not expose the refrigerator to direct sunlight, rain, snow, excessive moisture, etc..
20. Exercise particular caution when transporting the switched-on device in a car. Protect
against falling while driving.
21. WARNING: Keep space around the ventilation openings. Covering them will reduce the
cooling capacity and may damage the refrigerator.
22. Never connect the power cord to both the cigarette lighter and the electricity supply to
the refrigerator at the same time.
23. Only ready-made (wrapped) articles may be stored in the refrigerator.
24. Prevent the appliance from being upside down. Don't drop or shock it.
25. Store food in original packaging or containers intended for this purpose.
DEVICE DESCRIPTION:
1A. Control panel
1D. Power supply cable for the home electrical installation
2A. Mode switch - heating (HOT) / switching off (OFF) / cooling (COLD)
2B. Voltage switch – DC (12V ) / switching off (OFF) / AC (220-240V~)
2C. Car power socket 12V
2D. 220-240V~ power socket
3A. Mini fridge chamber with aluminum cavity
USING THE APPLIANCE
1. Ensure that the power switch (2A) on the control panel (1A) of the refrigerator is in the OFF position.
2. Device operation:
With 12V DC power supply:
a) Insert the other end of the cable with the plug (1C) into the cigarette lighter socket.
b) Set the voltage switch (2B) to DC.
c) Plug in the connector to the DC slot (2C).
d) Set the mode switch (2A) to: "HOT" when you want to heat the chamber or "COLD" to cool the chamber.
The power consumption on each setting is as below:
DC: Heating mode 32W / Cooling mode 36W
With AC220-240V power supply:
a) Plug in the connector to the AC slot (2D).
b) Set the voltage switch (2B) to AC.
c) Insert the other end of the cable with the plug (1D) into the electric socket.
d) Set the mode switch (2A) to: "HOT" when you want to heat the chamber or "COLD" to cool the chamber.
The power consumption on each setting is as below:
AC: Heating mode 38W / Cooling mode 42W
3. After finishing operation, set the mode switch (2A) and voltage switch (2B) to "OFF" and disconnect the wires.
WARNING: Don't switch the mode switch (2A) abruptly. Switch the function after 30 minutes of being on position: OFF.
Cleaning and Maintenance
1. Before cleaning make sure that the device is not connected to the power source.
2. The cleaning process is restricted to using a damp cloth with a little of washing up liquid on the inside and outside of the devices body.
NOTE: DO NOT PUT ANY FOREIGN OBJECTS INTO THE FAN TO CLEAN IT.
1B. Fan 1C. Car power cable
3B. Shelf 3C. Mini basket 3D. Handle
4
3E. Mirror