Tognana Iridea D2DBE17IRRO Manual De Usuario página 20

DANGER! DO NOT PUT IN THE DISHWASHER OR
SOAK IN LIQUIDS.
IMPORTANT NOTE
steel wool or abrasive cleaners for cleaning.
3. Clean the filter
The filter does not dissolve or eliminate limescale, keeping all water properties unchanged.
If very calcareous water is used, the filter could become clogged quickly (10-15 uses). It is
therefore essential to clean it regularly with a soft, wet cloth.
4. Storing
Allow the appliance to cool completely before storing it or wrapping the supply cable around it.
Check that there is no water inside the kettle.
Make sure all parts are clean and dry before storing them.
Never store the appliance when it is still wet.
It is recommended to store the appliance in a dry place, clean and away from moisture and
dust.
When not using the appliance, the power cord can be wrapped around the base of the kettle.
TROUBLESHOOTING
PROBLEM
Decreased efficiency in
pouring
The appliance shuts down
before reaching boiling
The appliance does not
turn on
The problem is not solved.
INFORMATION ON DISPOSAL
PRODUCT
Pursuant to art. 26 of Legislative Decree No. 49 of 14 March 2014 "Implementation of Directive
2012/19/EU on waste electrical and electronic equipment (WEEE)", the presence of the
wheeled bin symbol indicates that this product is not to be considered urban waste: Non-
separate disposal can be a potential harm to the environment and health. This product may
be returned to the distributor upon purchase of a new appliance.
: Do not use chemical detergents,
CAUSE
Presence of limescale in the filter Check the position and the
The bottom of the kettle has an
excessive limescale deposit
Little water has been poured or
there is no water
Activation of safety device due to
operation of the kettle without
water
The plug is not correctly inserted
into the power outlet
The cable is defective
Absence of electrical current
SOLUTION
cleanliness of the filter
Descaling more frequently
Increase the amount of water until it
reaches the minimum level
Let the kettle cool before activating
a new boiling cycle
Connect the plug into the power
outlet. Do not use adapters or
extensions. Check that the general
switch is inserted
Have the cable replaced at an
Authorised Service Center
Check that the general switch is
inserted
Contact your retailer or customer
support.
20