Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2. Attach each of the four or five wires to the Smart
Sync LED Adapter by pushing back an orange
spring clamp and inserting the correct wire below.
If needed, push back the orange spring clamps to
release wires. See Figure 3 for wire stripping and
insertion, Figure 4 for RGB wiring, and Figure 5 for
RGBW wiring.
3. Repeat steps 1 and 2 to connect wiring from the
Jandy Infinite WaterColors
See Figure 6 .
From Jandy Infinite WaterColors
14 VAC FROM LIGHT
CONTROLLER
14 VAC FROM LIGHT
CONTROLLER
Figure 4. RGB Wiring
From Jandy Infinite WaterColors
14 VAC FROM LIGHT
CONTROLLER
14 VAC FROM LIGHT
CONTROLLER
Figure 5. RGBW Wiring
Page 4
Jandy
Infinite WaterColors
®
LED Light Controller.
™
LED Light Controller
™
LED Light Controller
™
Smart Sync
LED Adapter | Installation & Operation Manual
™
™
Spring
Clamp
Figure 3. Wire Stripping and Insertion
Strip wires by at least ¼"
To compatible device
BLACK
GREEN
RED
WHITE
To compatible device
WHITE
BLUE
GREEN
RED
BLACK
Publicidad
