Descargar Imprimir esta página

Furrion LIPPERT PN Manual Del Usuario página 6

Horno microondas de convección integrado de 0.9 pies cúbicos con freidora de aire

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
What's in the Box
Make sure all the following items are included in the
packaging. If any item is damaged or missing, contact
your dealer.
● Microwave Oven Body x 1
● Roller Ring x 1
● Glass Tray x 1
● Bake Plate x 1
● Air Fry Kit
● User Manual
● Warranty Manual
NOTE: Trim Kit Sold Separately
● One-Piece Trim Kit:
- FMAML09-SS-TK (2023050377)
- FMAML09-BL-TK (2023050378)
Before Installation
1. Make sure that all the packing materials are removed from
the oven cavity.
2. Check the oven for any damage, such as misaligned or bent
door, damaged door seals and sealing surface, broken or
loose door hinges and latches and dents inside the cavity or
on the door. If there is any damage, do not operate the oven
and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface
to hold its weight and the heaviest food likely to be cooked
in the oven.
4. Do not place the oven where heat, moisture, or high
humidity are generated, or near combustible materials.
5. The oven must have sufficient airflow. Do not cover or block
any openings on the oven. Do not remove feet on which
oven stands.
6. Do not operate the oven without glass tray, roller support,
and shaft in their proper positions.
7. Make sure that the power supply cord is good in condition
and does not run under the oven or over any hot or sharp
surface.
8. The electrical outlet or circuit breaker must be accessible to
disconnect power in an emergency.
Microwave Oven Installation
Cutout Dimensons and Clearances
Overhang and surrounding cabinet material
requirements: If installing near a ceiling or directly under
the countertop and the area around the vent exhaust, use a
noncombustible material or a combustible material having
a minimum temperature rating of 90 degrees celsius (194F).
Minimum distance from the top of the microwave cutout to an
overhead noncombustible surface is 1".
Cabinet Preparation
1. Select a suitable place that is not susceptible to
moisture.
2. Mark and cut out an opening in the cabinet according to
CCD-0008388 Rev: 01.09.24
the dimensions outlined in the table.
NOTE: If a range hood is installed under the microwave oven,
1 inch minimum clearance must be reserved from the bottom
of the microwave oven to the top of the range hood. Refer to
dimension E.
A
14 5/8" (372mm)
21 7/16" (545mm)
Min. to 14 11/16"
Min. to 21 9/16"
(373mm) Max.
(547mm) Max.
Below Cooktop Installation Cutout Requirements
5/8
14
" (372mm) Min. to
11/16
14
" (373mm) Max.
● If installing this microwave under or next to a gas
or electric cooking appliance, the microwave must
be completely separated and/or sealed from the
cooking appliance.
- 5 -
Dimensions
B
C
D
16 1/8"
1/2" (13mm)
(410mm) Min.
Min.
7/16
16
" (418mm) Min.
Microwave
Cutout Bottom
7/16
21
" (545mm)
Min. to
9/16
21
" (547mm)
Max.
WARN ING
E
1" (26mm)
Min.

Publicidad

loading