When the ice holder is full
Note: When the ice is full, the "Ice full" indicator light lights up continuously.
•
When the ice holder is full, the compressor will stop working and an alarm will
sound.
•
Press the CLEANING button to enter cleaning mode. The device returns
directly to standby mode when the ice container is full.
•
The ice in the ice collection tray must first be removed before you can return
to ice making mode, cleaning mode or standby mode.
Turning on the light
Press the light button once to keep the ice tray light on. Press the light button
again to turn it off. The ice tray light can be turned on/off in any condition. After
the light has been on for 10 minutes, it will turn off automatically.
Freeze alert
During the ice making process, if the low water, full ice, cleaning and ice making
indicator lights are flashing at the same time and the CLEANING, LIGHT and ICE
MAKING buttons are on at the same time, this is a freeze alarm. In this situation,
the power supply must be interrupted immediately. Wait 4 hours for the ice in the
evaporator to melt before turning it on again.
Cleaning function
Press the CLEANING button in standby mode to enter cleaning mode. The
CLEANING indicator lamp lights up. In ice making mode, you cannot switch directly
fro ice making mode to cleaning mode by pressing the CLEANING button. You
need to press the ice making button (ON/OFF) to return to standby mode. Then
press the CLEANING button and the cleaning indicator light will light up. In the
cleaning process, the water pump continuously pumps water from the lower
water tank to the upper water tank and the water from the upper water tank flows
back to the lower water tank through the overflow opening. The device will rinse
continuously for 7 minutes and then return to standby mode after cleaning. When
the program detects that the lower water tank is low on water in the cleaning
mode, the water shortage indicator light will turn on and the device will return to
standby mode.
EN
21