Publicidad
Idiomas disponibles
Idiomas disponibles
When using the hair dryer in the bathroom, unplug
after use since the proximity of water presents a
risk even when the hair dryer is turned off. For addi-
tional protection, it is advisable to install a residual
current device (RCD) with a rated operating current
not exceeding 30mA in the electrical circuit suppl-
ying the bathroom. Ask your installer for advice.
WARNING: Do not use this device near bathtubs,
showers, sinks or other tanks that contain water.
This symbol means that the device should
not be used near bathtubs showers, sinks
or other water containers.
This device is designed for use at a maximum alti-
tude up to 2000m above sea level.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commercial or in-
dustrial use under any circumstances. Prior to plugging in the product, check that your
mains voltage is the same as the one indicated on the product label. The mains connection
cable must not be tangled or wrapped around the product during use. Do not pull on the
connection cord in order to unplug it. Proceed according to the conservation and cleaning
section of this manual for cleaning. Do not use the product to warm up animals. Unplug
the product immediately from the mains in the event of any breakdown or damage and
contact an official technical support service. In order to prevent any risk of danger, do not
open the device. Only qualified technical personnel from the brand´s Official technical su-
pport service may carry out repairs or procedures on the device. Any incorrect use or im-
proper handling of the product shall render the warranty null and void. Only an authorized
technical support service center may carry out repairs on this product.
B&B Trends, S.L. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
1. Plug the appliance to the electrical supply. Make sure it is set at the "off" position.
2. If required, attach the desired accessory.
3. Set the on-off button (8) to the I position to turn on the hair dryer. The LED display (10)
12
Publicidad
