Publicidad
Idiomas disponibles
Idiomas disponibles
Use the LEFT or RIGHT arrow key to select the
parameter you wish to view.
Each time the battery is turned off (stored),
"pause" mode is disabled and "cyclical"
display mode is automatically restored.
The
icon inside the battery shows the
battery is being charged.
7.5 Energy savings
The integrated BMS prevents the battery from
being damaged by excessively deep discharge.
Once the minimum charge threshold has been
detected, the BMS automatically switches off the
battery.
Caution! Switching off the battery can
cause direct damage to connected de-
vices and indirect damage to the sur-
rounding environment
("7.6 Storage procedure").
7.5.1 Control panel standby
In order to optimise energy savings, the control
panel will, if idle, go to "Standby" mode and the
display will shut down.
To exit "Standby" mode press the LEFT or RIGHT
arrow key and the control panel will display the
battery charge.
7.6 Storage procedure
Storage is a preventive battery shutdown proce-
dure intended to protect battery life and safeguard
against the damage that might stem from a bat-
tery self-shutdown 'commanded' by the integrated
BMS.
Proceed as indicated.
1. Check that all electrical/electronic devices
connected to the battery and equipped with a
switch are off.
Rev.001
2. Ensure that there are, between connected
3. Press and hold (5 seconds) the storage but-
("5.7
Storage")
TLI PREMIUM
Translation of the original instructions
devices, no elements subject to "active forc-
es" which, without power, could release load
and endanger nearby persons or objects (au-
tomatic tank emptying caps, solenoid valves,
lock pins, etc.). If necessary, follow the rela-
tive instructions for correct shutdown.
ton on the battery and then release it to ena-
ble storage.
Caution! With the control panel con-
nected, pressing the on/storage but-
ton on the battery has no effect. In this
case, the control panel slider must be
set to the OFF position.
Fig. 7
EN
- 17 -
Publicidad
